Problems changing the yarn dimensions for my material

[georgie]

Hi!

I am having some trouble changing my dimensions in TexGen. I have created a layer-to-layer model with no warp yarns only warp binders but I want to change the yarn dimensions to approximately width:3.5, height:0.5 for the yarns however when I change the dimensions there is always a big mess. I have attached an image of what happens when i use my dimensions. Any advice would be appreciated!

[louisepb]

Hi Georgie,
There doesn't seem to be an image attached. If you could include the parameters that you are using to create your textile that would be helpful too.
Best wishes,
Louise